EN 1/2 ASSEMBLY INSTRUCTIONS SLIDING DOORS Before setting up: Check that the interior measurements of the doors comply with the drawing. Item list Ceiling rail (length as per order) Floor rail (length as per order) 8 x Self-tapping screws 3.9 x 19 mm (TX 20) Double-sided adhesive tape Position stopper Bumper stopper Cover buttons only used for doors with height adjust- ment in side profile 1: It is a good idea to pre-drill holes in the ceiling rail for screws before installation. Mount the first and last screw 5 cm from the edge. 2: Attach the ceiling rail to the ceiling. If the ceiling rail is mounted in e.g. plaster/concrete, raw plugs and other types of screws must be used (not included). 3: P lace the floor rail loosely without any tape. 4: P lace the door in the ceiling/floor rail. Align the door vertically and mark where the floor rail is to be glued. 5: R emove the door again and mount tape on the floor rail. Mount the floor rail as marked. Insert the doors ready for adjustment. 6: P osition the door against the panel/ adapter wall. Adjust the door so that the distance is the same at the top and bottom. The adjustment is made on the bottom wheel These products are intended to be installed by a professional or skilled workman.
Download PDF fil