Page number 4
FlowCon FN.0.2, FN.0.2-BUS and FN.0.4 1B95080 - 06/2023 DIP Switch Settings The valve functions are set on DIP switches found under the connection cover. PCB mounted electri- cal components will not be directly exposed when DIP switches are to be set. Factory setting for all switches is OFF. FlowCon FN.0.2 Actuator DIP switch Function ON #6 Electrical override ON #5 No function % % #4 Equal percentage #3 %% Normally Open %% #2 Control signal 2-10V #1 Auto cycle ON 6 5 % 4 %% 3 2 1 Function OFF Electrical override OFF No function % Linear %% Normally Closed Control signal 0-10V Auto cycle OFF FlowCon FN.0.2-BUS Actuator DIP switch Function ON #8 Terminal resistor active #7 Mo M d od b b u us s Modbus BACnet #6 Asedtdtirn 1 egss BIT 5 = 1 Address setting #5 1 BIT 4 = 1 #4 1 BIT 3 = 1 #3 1 BIT 2 = 1 #2 1 BIT 1 = 1 #1 1 BIT 0 = 1 8 Modbus 7 Address setting 6 5 4 3 2 1 Function OFF Terminal resistor inactive B B A AC C n n et et BACnet Asedtd 0 tirnegss BIT 5 = 0 0 BIT 4 = 0 0 BIT 3 = 0 0 BIT 2 = 0 0 BIT 1 = 0 0 BIT 0 = 0 This paper is a supplement to the FlowCon General Instruction Latest release of any FlowCon material is available on www.flowcon.com Page 4 of 8
Page number 5
FlowCon FN.0.2, FN.0.2-BUS and FN.0.4 1B95080 - 06/2023 FlowCon FN.0.4 Actuator DIP switch Function ON #6 Electrical override ON #5 No function % % #4 No function #3 % Normally Open % #2 No function #1 No function 6 % 54 % 3 2 1 Function OFF Electrical override OFF No function % No function % Normally Closed No function No function LED Status The LED indicator is visible through the dark colored transparent connection cover. The LED indication will give the following statuses. Normal operation mode FN.0.2 Full on green FN.0.2-BUS Full on green FN.0.4 Full on green Charging mode (60 sec) Calibration mode (closing point adjustment) Bus communication mode n/a Blinking green n/a n/a Blinking green Flickering green n/a Blinking green n/a Mounting position mode n/a Rapid blinking green n/a Electrical override mode Blinking red/green n/a Blinking red/green Failsafe mode n/a n/a n/a Manuel spindle adjustment n/a Blinking yellow n/a Perpetual failure mode Full on red Full on red Full on red This paper is a supplement to the FlowCon General Instruction Latest release of any FlowCon material is available on www.flowcon.com Page 5 of 8
