EN 2/2 ASSEMBLY INSTRUCTIONS SLIDING DOORS – CORNER SOLUTION 6: P osition the door against the panel/adapter wall. Adjust the door so that the distance is the same at the top and bottom. The adjustment is made on the bottom wheel 7: I f there is air between the door and wall/adapter/panel in the middle of the side profile, knock the side profilen out with a small tapping block and hammer. This may be necessary as there are tolerances for the different materials in the door. Position stopper Inside of the top rail Top wheel 8: M ount the bumper stoppers. If impact tape has been additionally purchased, bumper stoppers do not need to be mounted. 9: P osition stoppers are mounted in the ceiling rail (on the vertical side). Mark where the top wheel is in correct position. Attach the position stop as marked. NOTE! For soft-close doors, see soft-close instructions. 10: If the doors are soft-close, it has to be fitted before fitting corner strips. When the soft-close has been fitted, the doors that are to be placed in the corner are removed ready for mounting the corner strip. 11: The side profile of the door must be horizontally aligned when mounting. Door side profile must be cleaned and dry before mounting corner strip. Mount corner strip with double-sided adhesive tape. Check the corner strip for secure overall fit. Corner strip is 25 mm lower than side profile and must be flush with bottom edge of side profile.
Download PDF fil