EN ASSEMBLY INSTRUCTIONS 93 SIDE PANEL A standard panel is supplied with excess height for trimming at the top and bottom if reduction is not selected. Item list Side panel Depth: 680 mm Height: Variable (Standard 2750 mm) 4 x angles 8 x screws 3.5 x 16 mm (Torx 20) 1: P lace the panel, making sure it is vertically aligned both ways. 2: M ount the panel with the supplied angles at the top and bottom, 100 mm from the front edge and rear edge. If a drilled panel is combined with a bottom plate or base, the panel at the bottom must be adjusted during installation. The distance of 16 mm up to the centre of the first system hole must now be measured from the top edge of the bottom plate/base. The panel is then cut at the top. Therefore, the height of the panel cannot be reduced at the factory in this combination. These products are intended to be installed by a professional or skilled workman.
Download PDF fil