Data sheet/installation instructions – article 9605 Trimming hanger rail to flex width. 1. Fix the brackets to the end pieces 2. Measure the width between the brackets, NOTE the dimension on line A 3. Remove the end plug on the hanger rail 4. Shorten the width of the hanger rail/LED strip so that the total length is (A) -1 mm 5. Then check on the LED strip that the two copper wires are not touching each other. 6. Fit the end plug. Wiring: • Wiring is individual; the cable tray supplied may be used if required. • Connect wire to driver. Operating voltage IP rating Kelvin Cable length Dimmable Connector Connection to Load capacity Motion sensor: Detection angle Range “Stay on time” Technical data 12V DC – 1000 mm = 5 W IP 20 4250–4500 – Neutral white 2000 mm No LED mini M1 Driver 12V Up to 40 kg/m 60 degrees 2 meters 40 seconds
Print
Download PDF fil