Page number 2

SECTION 2 – Service Saddles Bronze Service Saddles for cast iron, ductile iron, A-C pipe, & AWWA C900 PVC plastic pipe. ɡ THICK TAPPING BOSS –precision machined for a pressure tight connection that resists pull-out. ɡ HEAVY BODY – provides strength at critical stress points. Constructed of 85-5-5-5 ASTM B62 brass. ɡ STRAPS – Silicon Bronze are flattened to provide increased gripping surface.304L stainless steel - for additional pipe support.* ɡ ROLLED STRAP THREADS – for added strength. ɡ MANUFACTURED AND TESTED – in accordance with all applicable parts of ANSI/AWWA C800 – NSF 61 Certified. ɡ NITRILE O-RING GASKET –is cemented in place and confined in a retaining groove, for pressure tight seal on the main. ɡ BODY CURVATURE –designed to fit pipe accurately for secure clamping and uniform sealing pressure. *Stainless steel strap recommended for saddle used on AWWA OD C900 PVC & AC pipe. WARNING: Use on A-C pipe, which contains a known carcinogen, requires appropriate protective equipment and procedures be employed. Bronze Saddles for O.D. Controlled PVC Pipe ɡ THICK TAPPING BOSS – precision machined for a pressure tight connection that resists pull-out. Generous wrenching surfaces to provide sure grip while installing corporation valve. ɡ MANUFACTURED AND TESTED – in accordance with all applicable parts of ANSI/AWWA C800-NSF 61 Certified. ɡ NITRILE O-RING SEALED – glued in place and confined in a groove to resist cold-flow or distortion and provide a pressure tight seal against the main. ɡ SILICON BRONZE SCREWS – for strength and corrosion resistance (also hinge pin on swing hinge style). ɡ WIDE STRAP – is specially shaped to fit the contour of the O.D. controlled plastic main and seal dependably without pipe distortion. Double-wide straps on saddles with 1-1/2" or 2" tapped outlets for added stability. 2 Rev 5-19

Page number 3

SECTION 2 – Service Saddles Bronze Service Saddle with Single Bronze Strap • Outlet tapped with either AWWA taper (C.C.) or AWWA I.P. thread (F.I.P.T.) • For use on cast iron or ductile iron pipe • 200 psig (1379 kPa/14 bar) maximum working pressure • Brass body • Flattened silicon bronze straps • Roll strap threads • O-ring sealed outlet • 3/4" and 1" tap sizes • Meets all applicable parts of ANSI/AWWA C800 • NSF 61 Certified J-975 Series Nominal Pipe Size in Inches Pipe O.D. Range* Inch mm Thread Type CC 4" 4.47-5.32 121.0-135.0 IP CC 6" 6.84-7.45 174.0-189.0 IP CC 8" 8.99-9.67 229.0-245.0 IP CC 10" 11.04-12.12 281.0-307.0 IP CC 12" 13.14-14.58 334.0-370.0 IP 3/4" Tap Part Number 38-1219 38-1204 38-1222 38-1207 38-1225 38-1210 38-1229 38-1214 38-1231 38-1216 Tap Size 1" Tap Part Number 38-1250 38-1234 38-1253 38-1237 38-1256 38-1241 38-1260 38-1245 38-1262 38-1247 Rev 10-18 3

    ...