Installation Guide for TECH-system Type 322 BASIC Important information Important information concerning LINAK products is given under the following headings: Warning! Failure to comply with these instructions may result in accidents, leading to serious personal injury. NB! Failure to comply with these instructions may result in damage to or destruction of the product. Warranty The LINAK warranty covers manufacturing faults in the products, calculated from the date of production. For additional information about the warranty period, please contact LINAK Danmark A/S. The warranty is limited to the value of the LINAK product. The LINAK warranty is only valid if the system is unopened and has been used correctly. The control box and control unit must not be subjected to rough handling, as this will void the warranty. Safety instructions Please read the following safety information carefully. Everyone who is to connect, install or use the system must have received the necessary information and have access to these instructions. LINAK recommends that the actuator is used for push applications rather than pull applications. It is essential that everyone who is to connect, assemble or operate the systems receives the necessary information and has access these instructions. Before fitting, removal or troubleshooting: • Stop the actuator. • Disconnect the power supply or remove the mains plug from the socket. • Relieve the actuator of any load that can be released during the work. Before start-up: • Make sure that the system has been installed as described in these instructions. • Make sure that the voltage to the motor control unit is correct before connecting the system to the power supply • System connection. The individual parts must be connected before the motor control unit is connected to the mains. During operation: • If the motor control unit emits unusual sounds or smells, disconnect the mains power and any external battery. • Make sure that the cables are intact. • Disconnect the mains cable to mobile equipment before it is moved. • The products are suitable for both indoor and outdoor use. However, you should always check that individual products have the appropriate IP sealing class. (See the product label.) Page 4 of 18 May.2018 ver. 00 LINAK Danmark A/S - Mønstedsvej 9- DK-8600 Silkeborg -Telephone (+45) 86803611 - www.linak.dk
Download PDF file