TR-EM-288-SPF Positioning Driver Motor controller TR-EM-288-SPF is a servo controller designed to operate with a single actuator in applications requiring precise positioning of actuator movements. The motor controller has been developed to receive feedback from actuators with an integrated dual-hall sensor. DECLARATION TR-EM-288-SPF is declared to be in compliance under the designation TECH system 288-SPF in combination with LINAK-compatible actuators and controls in accordance with the machinery directive 2006/42/EC Annex I as a partly completed machinery with focus on the following: 1.2.1;1.2.2;1.2.3;1.2.4. 1;1.2.6;1.3.2;1.3.7;1.3.8. Technical data: • Power supply: 10-35 VDC (ripple-max. 30%) • Max. power limit: 15A duty cycle 100% 30A at start • Power limit, setting: 0.1-20A • Ramp times (start/stop): 0-2.5 sec. • PWM frequency: 2 kHz • Controller input: 0-5.5V /0-11V / 4-20mA • Control potential: PNP / NPN • Speed setting range: 20-100% • Stroke length limit: 0-50% • Input impedance: 10 k ohm • Operating temp.: (Ta): -40°C to 60°C Features • The motor controller can be set to disconnect the actuator motor when the power limit is exceeded and pre-set at intervals from 0.1–20 A using the portable serial interface handset TR-EM-236A. • Positioning the actuator can be carried out either by setting new values via a potentiometer handset or by setting a 0-5,5V; 0-11V; or 4-20mA signal from, for example, a PLC controller. • The controller has 25 parameters which can be set using a portable serial interface handset TR-EM-236A. Using these parameters you can adjust many settings, including speed, max. stroke length, power limit and ramp times. The specified product is produced by Electromen OY Specifications subject to change without prior notice. It is the responsibility of the product user to determine the suitability of the products for a specific application. LINAK Danmark will at point of delivery replace/repair defective products covered by the warranty if promptly returned to LINAK Danmark. No liability is assumed beyond such replacement/repair. LINAKTHIRDPARTY.COM LINAK® accepts no responsibility for possible errors or inaccuracies in catalogues, brochures, and other material. LINAK reserves the right to change its products without prior notice. LINAK cannot guarantee product availability and reserves the right to discontinue the sale of any product. The user is responsible for determining the suitability of LINAK products for a specific application. All sales are subject to the ‘Standard Terms of Sale and Delivery’, available on LINAK websites. LINAK and the LINAK logotype are registered trademarks of LINAK A/S. All rights reserved. . continues
Download PDF file