EM-273 PCB v.3 Single Hall feedback Voltmeter Act. 1 Act. 2 Act. 3 Act. 4 3 6 9 12 15 25 Hall potentiomete E r M f -2 e 73 e P d CB b v a .3 ck The drive can manag E e M-2 b 73 o PC t B h v.3 pulse feedback (reed / Hall sensor) or analogue signal 0-5/ 0-10 V (Hall potentiometer / potentiometer). Pulse feedback Check that there is a sig Act n . 1 al by Act. 2 Act. 3 Act. 4 measuring the voltage at terminal 6, 9, 12 and 15. At lack of signal, run the actuator 6 forwards and backward 2 s 021 to s 2 e 5 e the signal change from 12/24 V or 0 V. O A hm t m l e a te c r k of signal, check ca Ac b t. 1 les A a ct. n 2 d the Act. a 3 ctu Act a . 4 tor. Analogue feedback ( 3 Abso 6 lute p 9 osition 12 ) 15 25 Ch Vo e lt c m k eter that there is a signal by measuring the voltage on terminal 6, 9, 12 and 15. There must be a voltage of 0-5 V or 0-10 V. At lack of signal, check whether the actuator is fully retracted. If the actuator is fully retracted the signal will be 0 V. If the actuator is fully retracted, but no signal, check cables and the actuator. Reset the system, if necessary. EM-273 PCB v.3 Control signal (hand control) Ohmmeter Act. 1 Act. 2 6 Act. 3 Act. 4 20 21 25 Check whether there is a signal by running forwards and backwards. Either 5 or 24 V DC. The inlet is active from 3 to 32 V. EM-273 PCB v.3 Initialisation of the system 20 21 25 Reset the driver by activating FW/BW simultaneously for 3-5 seconds, or by activating the inlet on terminal 23. Frem FW Tilbage BW LINAKTHIRDPARTY.COM
Download PDF file