Page number 6
Connection diagram Applicable for: LA33, LA36, LA37, LA76 and LA77 Power BROWN BLUE 24/48 V DC GND Profinet™ User Manual | 6 Control RE1D BLA2CK 4* Extends the actuator Retracts the actuator 1 Split power supply V DC 1 2 4 3 2 2 1 2 1 5 5 3 4 3 Parallel data 4 5 Parallel GND 3 3 4 M12 A-Code Communication 1 ETH_TX+ 2 ETH_RX+ 3 ETH_TX- 4 ETH_RX- 1 2 1 2 4 3 4 3 M12 D-Code 2 5 2 5 3 3 The physical layer conforms to the IEEE 802.3-2018 standard with communication speeds of 10 Mbps and 100 Mbps, respectively. Cable length is reduced to = 100 m without repeater, as determined by IEEE 802.3-2018. * Split power supply and motor supply (Brown), which refer to a common GND (Blue). This approach is used to maintain power on the intelligent part of the actuator. In case the main supply is disconnected, split power supply allows e.g. that the position is maintained. The main supply may be disconnected for reasons related to safety, maintenance or installation. Actuator Connect ™ is available for Profinet ™ actuators and can be used for: Diagnostics, manual run and configuration. The newest version is available online here. Connect the actuator to Actuator Connect via a USB adapter cable (must be purchased separately) to enable and configure various features. Item number for cable kit: 0367996
Page number 7
Connection diagram Applicable for: LC3 IC Power BROWN BLUE 24/48 V DC GND Profinet™ User Manual | 7 Control RED BLACK ORANGE* VIOLET WHITE Extends the actuator Retracts the actuator Split power supply V DC Parallel data Parallel GND Molex mini-fit 12-pin Communication 1 ETH_TX+ 3 ETH_RX+ 2 ETH_TX- 6 ETH_RX- 8 1 RJ45 The physical layer conforms to the IEEE 802.3-2018 standard with communication speeds of 10 Mbps and 100 Mbps, respectively. Cable length is reduced to = 100 m without repeater, as determined by IEEE 802.3-2018. The wiring conforms to the T-568A standard. * Split power supply and motor supply (Brown), which refer to a common GND (Blue). This approach is used to maintain power on the intelligent part of the actuator. In case the main supply is disconnected, split power supply allows e.g. that the position is maintained. The main supply may be disconnected for reasons related to safety, maintenance or installation. Actuator Connect ™ is available for Profinet ™ actuators and can be used for: Diagnostics, manual run and configuration. The newest version is available online here. Connect the actuator to Actuator Connect via a USB adapter cable (must be purchased separately) to enable and configure various features. Item number for cable kit: 0367996
