LC3 Column Kit | 2 This kit user manual does not replace the user manuals of the included products 1. Get your Plug & Play LC3 lifting column kit You will receive the following parts: • 1-4 LC3 lifting column(s) • Black end plates • Control box(es) CO71 and blind plugs • Junction box(es) MJB5 and blind plugs • Operating panel TP1 • Motor and mains cable 2. Mounting the column(s) and accessories Column(s) • The lifting column can be mounted in both directions. Both IPX4 and IPX6 protections are obtained when mounting the largest profile upwards. When mounting the largest profile downwards, IPX4 is obtained. • The optional end plates offer easy mounting of the column(s) to e.g. worktops and directly on the floor. Start by mounting the bottom plate with the 4 x 45 mm M10 screws and repeat this process for the top plate with the 4 x 35 mm screws. Lastly, mount the column(s) in the application by using the 4 x M10 holes located in the top and bottom plates. If mounting more than one column: Fixate all columns to the worktop. If the application needs to be fixated to a firm foundation/base, only fixate one column to the foundation/base to prevent the columns from bending if they do not move in perfect parallel. Control box and operating panel • It is recommended that the control box CO71 is mounted in a position that allows water to escape. Mount the control box using the bracket with M4 nuts (see picture below). Open the lid of the box with a slotted screw driver to mount the cables. • Mount the operating panel on a surface using the panel mounting bracket (see picture below). Control box mounting bracket The bracket has 3 x M4 holes for mounting of the control box 63,0 5,0 Panel mounting bracket The operating panel TP1 is mounted with a 45° bracket 45° 10,0 8,0 52,0 24,0 ® Danmark 16,5 35,5
Download PDF file