LINAK—Page 4

LINAKIntegrated Controller User Manual | 17 BusLink software tool and the parallel system The BusLink software tool is available for parallel and can be used for: Configuration, manual run and diagnostics (service counter) The BusLink software can be downloaded here. For more information and easy set-up of BusLink, please follow this link to view the User Guide for BusLink. Please note that the BusLink cables must be purchased separately from the actuator! Item number for BusLink cable kit: Only through the BusLink software tool is it possible to state if the system is Parallel or Non-Critical Parallel. Via this tool it is also possible to reconfigure the whole system from one system to the other. The parallel system • The actuators can be powered by the same or separate power supplies, but if separate supplies are used, it is crucial that all power supply grounds (GNDs) are connected together and that the power supplies have the same voltage output. Please respect the actuator specifications regarding voltage level and current consumption! • If an overload occurs, the running of the actuators will be stopped and blocked in that direction until an activation in the opposite direction has been made, or the system has been re-powered. • When changing the actuator configuration, it is important that all actuators in the system have the same configuration before the system starts running. Otherwise, the actuators will not run. • When actuators are networked, control of their movement is achieved by applying a signal to the IN or OUT wire on one, several, or all actuators. By default, actuators begin moving IN/OUT when voltage V DC is applied to the Red or Black wire. • Actuators will be pre-programmed from production as 2, 3, 4, 5 etc. parallel systems. Through BusLink it will be possible to add or remove actuators to/from the system. • Before entering BusLink mode, all actuators must be disconnected. It is only possible to configure one actuator at a time through BusLink. • When all actuators are connected, a Master will automatically be chosen. E.g. with 5 actuators in one system there will be 1 Master and 4 Slaves. The Master can control up to 7 Slaves. • If a run out and run in command are given simultaneously to any actuator, the system will stop. To resume movement, one of the commands must be released. Similarly, if an outward command is given to any actuator and an inward command to another at the same time, the system will stop. Movement will resume when one of the commands is released. • In case an actuator drops off the line due to e.g. a damaged signal cable, the parallel system will stop immediately.Page 3Page 5

Page number 4

Terms of use Integrated Controller User Manual | 4 LINAK ® takes great care in providing accurate and up-to-date information on its products. However, the user is responsible for determining the suitability of LINAK products for a specific application. Due to continual development, LINAK products are subject to frequent modifications and changes. LINAK reserves the rights to conduct modifications, updates, and changes without any prior notice. For the same reason, LINAK cannot guarantee the correctness and actual status of imprinted information on its products. LINAK uses its best efforts to fulfil orders. However, for the reasons mentioned above, LINAK cannot guarantee availability of any particular product at any given time. LINAK reserves the right to discontinue the sale of any product displayed on its website or listed in its catalogues or in other written material created and produced by LINAK, LINAK subsidiaries, or LINAK affiliates. All sales are subject to the ‘Standard Terms of Sale and Delivery for LINAK A/S’ available on LINAK websites. LINAK and the LINAK logotype are registered trademarks of LINAK A/S. All rights reserved.

Page number 5

IC Basic Connection diagram Applicable for: LA14 and LA25 Power BROWN BLUE 12/24 V DC GND Control RED BLACK Extends the actuator Retracts the actuator Feedback YELLOW GREEN Endstop reached in Endstop reached out Integrated Controller User Manual | 5 AMP 2 1 Deutsch 4 3 5 6 Please be aware that if the power supply is not properly connected, you might damage the actuator!