Page number 6
Safety instruction LA10 system | 6 General Safe use of the system is possible only when the operating instructions are read completely and the instructions contained are strictly observed. Failure to comply with instructions marked with the ”NOTE” symbol may result in serious damage to the system or one of its components. It is important for everyone who is to connect, install, or use the systems to have the necessary information and access to this User Manual. Follow the instructions for mounting – risk of injury if these instructions are not followed. The appliance is not intended for use by young children or infirm persons without supervision. If there is visible damage on the product it must not be installed. Note that during construction of applications, in which the actuator is to be fitted, there must be no possibility of personal injury, for example the squeezing of fingers or arms. Only the power supply type SMPS001 or SMPS006, shall be used with the system (LA10 System). The power supply shall not be covered while operating to allow sufficient cooling of this appliance. The appliance is only to be used with the power supply unit provided with the appliance. Furthermore take care about the connecting wires from the power supply to the LA10 System, do not damage this by overrun. Assure free space for movement of application in both directions to avoid blockade. Safety issues The builder of the equipment shall ensure that the use of the component complies with relevant standards – like the Machine Directive. Care must be taken to avoid squeezing of cables as it can cause movement of the system! The SMPS001/006 must not be packed in heat insulating material, but must be placed so that it can emit waste heat to the surroundings. There are no ventilation holes to consider, the SMPS emits heat through its surface. Only the power supply type SMPS001 or SMPS006, or similar suited products meeting the requirements EN 60335-1, shall be used with the system (LA10 system).
Page number 7
Before installation, re-installation, or troubleshooting • Stop the actuators • Pull out the mains plug. • Relieve the actuators of any loads, which may be released during the work. LA10 system | 7 Before start-up • Make sure that the system has been installed as instructed in this User Manual. • Make sure that the SMPS voltage matches the mains voltage before the system is connected to the mains. • System connection. The individual parts must be connected before the SMPS is connected to the mains. See the User Manual for LINAK actuators, if necessary. During operation • If the SMPS makes unusual noise or smells, switch off the mains voltage immediately. • Take care that the cables are not damaged. Only for EU markets This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision. Only for Non EU markets Persons who do not have the necessary experience or knowledge of the product/products must not use the product/products. Besides, persons with reduced physical, sensory or mental abilities must not use the product/products, unless they are under surveillance or they have been thoroughly instructed in the use of the apparatus by a person who is responsible for the safety of these persons. Moreover, children must be under surveillance to ensure that they do not play with the product. Misuse Do not overload the actuators – this can cause danger of personal injury and damage to the system. Do not use the system in environments other than the intended indoor use.
