Page number 44
Resetting the reminder 1. Press symbol for eight seconds to reset reminder to default values. After five seconds the display shows a countdown and the light strip flashes red when the reminder is reset. Figure 41: Reset reminder Key lock The operation of DPG1C can be locked to prevent unintended driving of the desk. As default the key lock is disabled. If enabled, it automatically locks the DPG1C after a configured amount of time. The key lock function can also be configured to indicate attempt to operate the locked DPG1C by showing a red light and a . Unlocking DPG1C 1. Press , and in sequence (max. one second between each button press). Page 44 of 71
Page number 45
Troubleshooting/FAQs Error codes (only DPG1C) The DPG1C shows error codes generated in the CBD6S in case of errors in the system. The most common errors loop between the error code (EXX) and the error text, check the codes below: Error codes E53-E64 E41-E52 E01 Cause COLLISION OVERLOAD INITIALISATION Software versions before SW 1.13 only show error E01. Factory reset (only DPG1M, DPG1B and DPG1C) Press and hold the and buttons for eight seconds to set the DPG to factory default. The LED/light strip flashes red three times to indicate the reset is done. If a factory reset is performed, it sets the DPG back to the configured state, i.e. all configurations made in the DPG configurator will not be reset – only the settings changed directly on the DPG or in the app by the end users will be reset. DPG1C only During reset, the display lights up after five seconds, showing an arrow with a countdown [seconds] and RESET Figure 42: Reset to factory default (DPG1B and DPG1C) Figure 43: Reset to factory default (DPG1M) Page 45 of 71
