SETTING OWN AREAS (USER ASSIGNED MULTIPLE AREAS) 1. Enter your code - status of all areas displayed. 2. Press Ò 2 times for setting of all areas or 3. Press Õ for setting individual areas - area status for the first area is displayed. 4. Press Ò to set the first area. 5. Press Ö to see the next area. 6. Press Ò to set the next area. 7. Press × for return to status display. 8. Press × to log out. SETTING FAULTS In case of set faults, the buzzer sounds in the control panel for 1 seconds and the input name and set fault are displayed. Remove the cause of the alarm and make a new setting. If the error can not be removed, the alarm input can be inhibited, as follows: Inhibit alarm input 1. Enter your code. 2. Press Ò for setting - setting fault i displayed. 3. Press Ó to inhibit. 4. Press Ò for setting. 5. Press Ò for Yes to inhibit. 6. Press × to log out. ALARM RESET If the system has been in alarm, it is necessary to reset this. To reset the alarm, follow these steps. 1. Enter your code - sirenes will stop. 2. Press if necessary on Ó to unset. 3. Press Ö to see the number of alarms. 4. Press Õ to see the first alarm. 5. You must remove the alarm cause before you can reset the alarm. 6. Press to reset the alarm or 7. Press Ö to see the next alarm. 8. At the end of the list, the number of alarms is displayed. 9. Press Ò, if you want to set the area. 10. Press × to log out. Call G4S Control Center and give G4S your subscription number or address and password. G4S Security Services A/S, Roskildevej 157, 2620 Albertslund Tlf.: 70 33 00 40, Web: www.g4s.dk 08.01.2020 / ProductManagement - KLP/je
Download PDF fil