FlowCon E-JUST 15-50 mm (1/2”-2”) 1B95015 - 02/2020 Installation and Operation Instruction The FlowCon E-JUST inserts are used with three different FlowCon valve housings:  FlowCon A DN15-25 (1/2”-1”)  FlowCon AB DN15-50 (1/2”-2”)  FlowCon ABV DN15-40 (1/2”-1 1/2”) Insert Setting and Installation Prior to installing the FlowCon E-JUST insert (supplied from factory in setting 4.2) in the valve housing, the system should be properly flushed. Blank valve covers are available to be installed during flushing.   It is recommended to grease the O-rings located around the E-JUST with silicone grease before installing the insert in the valve housing.  Figure 1 The desired flow rate is set by adjusting the insert with a special adjustment key. Scale setting is located on the ‘neck’ of the insert where the white digits printed on black, numbered 1 to 5, indicate full turns and the top white digits printed on the red counter wheel, numbered 0 to 9, indicate 1/10 of full turn. Flow setting may be done either before or after the insert is installed in the valve housing. General Assembly Drawing FlowCon E-JUST A: Valve housing B: E-JUST insert C: Adjustment key D1: P/t plug (2 pcs.) D2: Plug (2 pcs.) E: Union end connections D1 D2 B E A C C E Figure 2 This paper is a supplement to the FlowCon General Instruction Latest release of any FlowCon material is available on www.flowcon.com Page 1 of 4

    ...