FlowCon UniQ ® 1B95038 - 05/2022 Installation and Operation Instruction The FlowCon UniQ ® is available in three dif- ferent versions: FlowCon UniQ ® DN15 (1/2”), female/female FlowCon UniQ ® DN20 (3/4”), female/female FlowCon UniQ ® 20mm (3/4”), male/male for EuroCone + Figure 1 Setting and Installation Prior to installing the FlowCon UniQ ® , the sys- tem should be properly flushed. If this is not pos- sible, please make sure to adjust the valve to setting 5.0 and then flush. The desired flow rate is hereafter set by adjust- ing the valve (turned from setting 1.0 and up) with a special adjustment key for rough setting or a special designed adjustment wheel for a mi- crometer setting. The wheel can only be placed one way on the valve. Make sure there is no gap between the wheel and the valve. Scale setting is located on top of the valve and position is de- fined by n indication mark on top of the housing. Once flow is set, the required actuator may be applied. Please see specific installation instruc- tion for selected actuator. General Assembly Drawing FlowCon UniQ ® A: FlowCon UniQ ® valve (here with 20 mm male (ISO) E suitable for DN15 EuroCone) B: Adjustment key C: Adjustment wheel D: EuroCone union end connections (here 15 mm male) B E: Actuator (here FlowCon EV.0.2). A D D C Figure 2 This paper is a supplement to the FlowCon General Instruction Latest release of any FlowCon material is available on www.flowcon.com Page 1 of 2
下载PDF文件