FlowCon Essentia 05/2024 Installation and Operation Instruction The FlowCon Essentia is available in four different versions: FlowCon Essentia DN15 (1/2”), female/female FlowCon Essentia DN20 (3/4”), female/female FlowCon Essentia DN25 (1”), female/female FlowCon Essentia DN15 (3/4”), male/male + + Setting and Installation Prior to installing the FlowCon Essentia, the system should be properly flushed. If this is not possible, please make sure to adjust the valve to setting 5.0 and then flush. The desired flow rate is hereafter set by adjust- ing the valve (turned counter-clockwise to set- ting 1.0 and then clockwise up) with a special adjustment key. Range is between 1.0 and 5.0. Do not over- turn. Figure 1 Scale setting is located on top of the valve and position is defined by an indication mark on top of the housing (figure 2). Once flow is set, the required actuator may be applied. Please see specific installation instruction for selected ac- tuator. Turn to higher settings Turn to setting 1.0 Indication mark Figure 2 B A C1 C2 General Assembly Drawing FlowCon Essentia A: FlowCon Essentia valve B: FlowCon actuator D (here shown EV.0.3 incl. adaptor ring) C1: P/t plug (2 pcs.) C2: Plug (2 pcs.) D: Adjustment key. Figure 3 This paper is a supplement to the FlowCon General Instruction Latest release of any FlowCon material is available on www.flowcon.com Page 1 of 2
Download PDF file