FlowCon FBT - Bluetooth Commissioning Meter 1A95130 - 03/2022 Installation and Operation Instruction The Bluetooth® Commissioning Meter FlowCon FBT is a pressure and flow meter with integrated Bluetooth® communication, intended for HVAC applications. In combination with the FlowCon App, the FlowCon FBT can provide system readings via Bluetooth®. Data includes ΔP and Flow based on selected valve and setting. The FlowCon FBT consists of a handle and a plug-in module. The module is as standard 0-700 kPaD (PT85 for FBT25), alternatively a module with a wider range of 0-2000 kPaD (PT86 for FBT30) can be selected. Step 2: Bluetooth® Connection 1. Turn the FlowCon FBT on by pushing the on the front of the handle for 3 seconds until the LED starts blinking. First it will very shortly show a green constant light, then it will shortly blink in yellow and turn into blinking rapidly in blue. This indicates that the FBT is ready for Bluetooth® connectivity. It will stay in this mode for 60 seconds. If it is not connected to a smart phone during this period, it will auto- matically switch power off. Step 1: Fitting Plug-in Module and Hoses 1. Remove the top cover by pushing the release button on the backside of the handle and pull out the cover. 2. Fit the FBT plug-in module in the handle, knob facing forward, and push until it clicks in place. If it needs to be taken out, release the plug-in module by pushing on the release button on the backside of the handle and then pull the plug-in module out. 3. Connect the hoses to the plug-in module. Blue hose connects to blue fitting and red hose connects to red fitting. 2. Connect smart phone and FlowCon FBT via Bluetooth® menu. The LED on the FBT will now blink slowly green. 3. Open the FlowCon App and follow these steps: • Tap ‘Connection’ and press ‘Search’ . • From the list you should see CAPBs PTxx. Select this and press ‘Add’ . • From the next page select the ‘Product Type’ from the dropdown menu and edit Max. Flow or Setting if required (setting is only visible where applicable) and tap ‘Add’ . • Tap CAPBs PTxx and get the readings on ΔP and flow on the following ‘Information Page’. Pressure- and flow units can be chang- ed in the App under ‘Setting’. 4. Finger-turn the knob on the FBT clockwise until end position. Note: that for any actuated valve, measurement can only be done with actuator fully open allow- ing max. flow according to setting. IT IS IMPORTANT to connect the FlowCon FBT to the App BEFORE fitting the p/t needles in the valve p/t plugs. This paper is a supplement to the FlowCon General Instruction Latest release of any FlowCon material is available on www.flowcon.com Page 1 of 2
Download PDF file