WASTE HEAT RECOVERY Aalborg WHR-GT INERT GAS SYSTEMS SMIT GAS™ The products shown in the form are a selection from our comprehensive product range that are specially suited for FPS applications. Aalborg TFO HEAT EXCHANGERS VESTA™ MP-C 10.0 – 50.0 t/h 500 – 30,000 m3/h 100 – 20,000 kW 300 – 2,000 kW Aalborg WHR-GT heat recovery unit (WHRU) is designed for installation after a gas turbine. The WHRU is supplied in various configurations such as supplying 40 bar superheated steam to power generation, saturated steam, or hot water for the process. Aalborg WHR-GT can be supplied as a ready module with exhaust gas by-pass damper for load modulation, or as a single element to build into the exhaust duct. Our design offers the best solution in respect of efficiency, accessibility, weight and footprint. Special advantages for Aalborg WHR-GT are low maintenance cost, high reliability and simple control; enabling easy integration into any existing control system. For converted crude oil tankers, the existing flue gas type inert gas installation will have to be refurbished. For newbuilding projects or in case of decommissioning of the boilers, an independent inert gas generator is installed. The inert gas systems supplied are often equipped with dual fuel burners (Ultramizing burner®). Most FPSOs are fitted with a double system for full redundancy. On board FPSOs and FSOs, the inert gas system execution may be a standard inert gas generator for installation below deck (engine room) or suitable for installation on deck in non or classified areas. Complete packaged inert gas units are supplied. The oil and gas-fired thermal fluid heater is constructed with a double coil system of large bare tubes and can be delivered in vertical or horizontal design. The design pressure is 10/13 bar, and the thermal fluid design temperature is 280–350°C. The heater has a low thermal fluid pressure drop and comes in a threepass flue gas configuration with a heavy insulation jacket. A removable top plate provide access for inspection and cleaning of the coils. Consisting exclusively of AISI 316 L materials, the VESTA™ MP-C shell & tube design cargo heater is the ideal choice when heating of oil or corrosive storage is required. The heating surface is optimized by the use of specially designed baffle plates resulting in a very compact, highly efficient, and cost-effective heater. The VESTA™ MP-C can be delivered complete with accessories such as valves, monitoring equipment and regulating equipment.
Download PDF file