Page number 1

JONES® SERVICE FITTINGS Shaded area indicates change Rev. 12-14 8.1 General Information 1. All Jones service fittings are manufactured in accordance with the AWWA Standard C-800-latest revision. 2. All fittings are tested individually. 3. Replacement components for compression fittings are available from your Jones distributor. 4. Packaging information is located in the Net Trade Sheet. Thread Abbreviations: - F.I.P. indicates Female Iron Pipe thread. - M.I.P. indicates Male Iron Pipe thread. - CS indicates Corporation Stop thread. - "Super Grip" indicates Jones 110 Compression Connection (interchangeable with any 3/4" or 1" Jones compressionfittingfortubesize).* 5. Pipe wrenches should not be used to install service fittings. A smooth jaw wrench should be used on the flata area of the body. *All service brass will comply with AWWA C-800. Components in contact with potable water will also comply with latest requirements of the Federal Safe Drinking Water Act. JONES 110™ Compression Connection (Super Grip) Features ❏ ENTIRE GASKET - is enclosed to resist cold flow and creep. ❏ GASKET - compresses concave gripper band and seals against fitting body, pipe and nut. Uniform pressure is applied around the concave gripper, forcing each outer edge to grip the pipe for pull-out resistance. ❏ FLUOROCARBON COATING - on inside surface of nut reduces tightening effort and avoids gasket distortion. ❏ PRESSURE RATING The pressure holding capability of the JONES 110™ Compression Connection (Super Grip) is designed to be greater than that of the valve or fitting on which it is used (only in potable water distribution applications complying with AWWA standards). ❏ GRIPPER BAND - is stainless steel and overlaps itself so no gasket material can get underneath. ❏ NUT - corrosion resistant cast bronze ASTM B584 (85-5-5-5) or Low Lead. ❏ TWO DESIGNS conductive compression connection fits type "K" copper tubing and CTS O.D. PE plastic tubing. A separate design fits IPS PE plastic pipe. Recommended stainless steel liners for plastic tubing and pipe available. ❏ CONDUCTOR SPRING - provides metal-tometal contact between copper tubing and fitting for electrical conductivity. ❏ NUT - bottoms out on shoulder of coupling to give quick visual indication of proper tightening. *See charts on pages 8.14-8.15 for tubing, pipe, and liners that may be used with these connections.