Page number 1

SECTION 4 – Curb Valves General Information 1. All Jones Corporation Stops are manufactured in accordance with the AWWA Standard C-800-latest revision. - Copper Alloy CDA No. 89833 (Low Lead) - Copper Alloy CDA No. C83600 (85-5-5-5)** 2. Maximum pressure rating (all Jones Curb Valves are tested individually): 3. Pipe wrenches should not be used to install Curb Valves. A smooth jaw wrench should be used on the flat area of 4. It is recommended that all pressure testing be done prior to backfilling. 5. Replacement components for compression fittings are available from your Jones distributor. 6. Box quantities are located in the Net Trade Sheet. the body. **All service brass will comply with AWWA C-800. Components in contact with potable water will also comply with latest requirements of the Federal Safe Drinking Water Act. Ball Curb Valve ɡɡ END PIECES O-RING SEALED - to provide additional protection against leaking. ɡɡ MANUFACTURED AND TESTED - to ANSI/AWWA C800 Standard. ɡɡ DOUBLE O-RING SEALS - are supported in precision machined grooves and provide secure, leak - tight sealing. ɡɡ SUITABLE - for use as test valves on Backflow Preventers (complies with Notice 89-001 of F.C.C.C. and H.R.). ɡɡ 300 PSIG - maximum working pressure. ɡɡ QUARTER TURN CHECK - is integrally cast on body to assure positive action. Checkless 360° turn is optional. ɡɡ FLUOROCARBON COATED BALL - ensures smooth, easy turning operation. ɡɡ BLOW-OUT-PROOF STEM DESIGN - prevents separation and assures dependable, safe operation. ɡɡ OPTIMIZED KEY TO BALL CONNECTION - provides strong, reliable performance and resists breakage. ɡɡ FULL THREAD DEPTH - and drill depth on F.I.P. thread ends (meets ANSI/ AWWA C800 Standard). ɡɡ FULL ROUNDWAY - provides straight - through flow (reduced port available). ɡɡ STAINLESS STEEL REINFORCED SEAT assures reliable seal under full flow and pressure. ɡɡ END CONNECTIONS - include copper flare, JONES® 110 Compression Connection, Pack Joint Connection, Copper Flare, M.I.P and F.I.P. thread and Jones Grip.* ɡɡ HEAVY BRASS COMPONENTS - constructed of ASTM 584 or brass for strength and durability. *See charts on pages 5-6 for tubing and pipe that may be used with these connections. Rev 10-18 1