Page number 12

SECTION 1 – Corporation Valves Corporation Valves Parts and Accessories J-1860 Part Number J-1860 J-1553 J-15535 J-15540N J-10048 J-1553 J-15535 J-15540N J-10048 Description Flaring Tool - Used to make 45º Copper flare nut Solid Copper Disc - Used with regular copper flare nut to shut off line. Brass Cap - Fits on copper flare spud to cap off line Corporation Valve Wrench - For operating up to and including 1" corporation valves. Sizes 1/2" 5/8" 3/4" 1" 1-1/4" 1-1/2" 2" 1/2" 3/4" 1" 1-1/4" 1-1/2" 2" 1/2" 3/4" 1" 1-1/4" 1-1/2" 2" 3/4" 1" - J-18010 J-18005 Part Number J-18010 J-18005 J-18025 Description Reamer - Used to ream the inside of type "K" copper tubing to remove burs prior to flaring Drilled Flaring Tool - Used to make 45° flare on type "K" copper tubing without shutting off water-drilled to exhaust water at right angle to tubing Brass Hammer - Solid brass head with 10" wooden handle - Weight 2-3/4 lbs. J-18025 Sizes 1/2" 3/4" 1" 3/4" 1" - Note: When using any striking tool, safety eye protection must be worn. Inspect hammer and tools for any damage after each use and repair or replace if mushrooming or chipping is evident. JONES Corporation Valves are manufactured and tested in accordance with ANSI/AWWA C-800. Components in contact with potable water will also comply with latest requirements of the Federal Safe Drinking Water Act. *See charts on pages 8-9 for tubing and pipe that may be used with these connections. 12 Rev 10-18