Page number 12

9.12 Rev. 9-17 Shaded area indicates changes D-5 ™ /DH-5 ™ Machine Control Valve Bushing H-17125 Installation Test Cap Completion Plug Wrench Drilling MAOP* Power Operator Machine Adapter Machine Adapter Bushing Boring Bar Extension Cutter Arbor Shell Cutter Pilot Drill Cutting Grease Honing Stone Stopping MAOP* Stopping Machine Machine Adapter Stopper Holder Solid Rubber Stopper Top Bypass Rubber Stopper Rubber Stopper Lubricant Inserting MAOP* Inserting Machine Machine Adapter Boring Bar Adapter Extension Inserting Tool Extracting MAOP* Extracting Machine Machine Adapter Extracting Tool Adapter Extracting Tool *Maximum Allowable Operating Pressure Replacement Rubber Replacement Rubber MUELLER ® NO-BLO ® LINE STOPPER FITTING H-17125 2" H-10918 3" - 036813 581264 250 psig H-604 47394 507783 64297 88470 36337 36336 88366 682560 250 psig D-5/DH-5 89946 580932† 88478 36290 88471 36298 580657 250 psig D-5/DH-5 47394 64297 36190 250 psig D-5/DH-5 47394 36198 83213

Page number 13

MUELLER ® NO-BLO ® BOTTOM OUT LINE STOPPER FITTING WELDING TYPE FOR STEEL PIPE o Catalog number – H-17125 -99004 o Size – 2" o For use on steel pipe only o Meets all applicable parts of D.O.T/CFR TITLE 49 PART 192 o O-ring sealed completion plug makes primary seal o Fitting top and bottom halves are forged steel (ASTM A105) o Cast iron completion cap makes secondary seal o 250 psig* (1724kPa) maximum working pressure Quantity per carton 2" 3 9.13 Shaded area indicates change Rev. 9-17 H-17125-99004 Pipe Dimensions Size of Line Stopper Fitting 2" Outside Diameter of Shell Cutter Required (Inches) 2.250 Outside Diameter of Pipe (Inches) 2.375 Inside Diameter of Bottom Opening 1.75" Drilling/Line Stopping Machine combinations that can be used to install & stop-off H-17125-99004 fittings Drilling machine D-5 or DH-5 Line stopping machine or unit D-5/DH-5 H-17125-99004 fitting size 2" Unit No.1 2" Replacement Parts Fitting size 2" Completion cap 36312 Completion plug 501707 Completion plug o-ring 79506 * This is the maximum pressure of the fitting installed in the line at 100F for Class Locations 1, 2, 3 and 4 as defined in D.O.T./CFR TITLE 49 PART 192. It may be necessary to reduce the line pressure during the drilling, stopping or plugging operations to the maximum working pressure of the machine or its attachments. Refer to charts on following pages.

    ...