11.14 Shaded area indicates change Rev. 12-06 MUELLER ® SIDE-OUT STOPPER FITTING WELDING TYPE - 275 PSIG o Catalog number – H-17355 o Sizes – 3", 4", 6", 8", 10", 12" Completion Cap o For use on steel pipe only Completion Cap o O-ring sealed cast iron (ASTM A126 CLB) Completion Plug with Bolts and Nuts equalizing valve (part # 580912) o Flange, fitting top and bottom halves are forged steel (ASTM A105) Completion Plug O-ring o Completion Cap cast iron (ASTM A126 CLB) o Pipe pup included for alternative welding options. o Class 150 flange complies with dimensional requirements of ANSI B16.5 o 275 psig** (1896 kPa) maximum working pressure at 100F (38C) Test Plug Gasket Equalizing Valve Completion Plug Assembly H-17355 Pipe Dimension Size* of Line Stopper Fitting 3" 4" 6" 8" 10" 12" Outside Diameter of Shell Cutter Required 3-1/4" 4-1/4" 6-1/4" 8-1/4" 12-1/2" 12-1/2" Outside Diameter of Pipe 3.500" 4.500" 6.625" 8.625" 10.750" 12.750" Maximum Wall Thickness No limit No limit .432" (sch. 80) .406" (sch. 60) No limit .375" Pipe Dimensions Minimum Wall Thickness .188" .188" .250" .250" No limit .188" Maximum Inside Diameter 3.124" 4.124" 6.125" 8.125" No limit 12.374" Drilling/Line Stopping Machine combinations that can be used to install and stop-off H-17355 Fittings Line Stopper Units Drilling Machine Unit No. 2 Unit No. 3 Unit No. 3SW Unit No. 3SW-500 Unit No. 4SW H-17355 C1-36 3" and 4" 6" and 8" 4", 6", and 8" 4", 6", and 8" 10" and 12" Replacement Parts Fitting Size* Completion Cap 3" 36590 4" 36592 6" 36609 8" 36625 10" 61867 12" 61867 Test Plug 64134 64134 64134 64134 64134 64134 Completion Cap Bolts and Nuts (No. Required) 503708 (6) 36731 (8) 36446 (8) 503709 (8) 52056 (12) nut 90230 (12) bolt 52056 (12) nut 90230 (12) bolt Completion Cap Gasket 43959 36377 62945 63094 46434 46434 Completion Plug Assembly 83484 83485 83487 83493 83560 83560 O-ring Seal 43922 43917 79895 79020 46428 46428 Pipe Pup - 528748 528742 528756 528760 528764 *Nominal **This is the maximum pressure of the fitting installed in the line at 100F for Class Locations 1, 2, 3 and 4 as defined in D.O.T./CFR TITLE 49 PART 192. It may be necessary to reduce the line pressure during the drilling, stopping or plugging operations to the maximum working pressure of the machine or its attachments.
Download PDF file