CORNER SOLUTION ▀▀▀▀▀▀▀▀▀▀▀▀▀▀▀▀▀▀▀▀▀▀▀▀▀▀▀▀▀▀▀▀▀▀▀▀▀▀▀▀▀▀▀▀▀▀▀▀▀▀▀▀▀▀▀▀▀▀▀▀ Tips · · · · · · · · To utilise the corner, you need a back wall of at least 1,500 mm in order to achieve a functional solution. Roof plates of more than 1,500 mm should be supported by a flex panel in order not to bend. If possible, place a panel by the door overlap.Place the pull-outs at each end of the wardrobe. This way you can be sure that the pull-out will not be obstructed. Pull-outs placed behind the door overlap cannot be pulled out. The back edge of corner shelves must be at least 800 mm. Always order two corner strips. Corner stops for soft-close function will be included in the delivery for the two doors that meet at the corner. The standard procedure is to place the two doors that meet at the corner in the innermost track. If you have a stand-alone wardrobe with a visible backing, always use a finishing strip on the external panel. The backing must go from the floor to the ceiling or to the upper edge of the roof. · If the wardrobe is in a niche, the external panels must instead have grooves and the backing must be placed onto a bottom/base and under roof, if applicable so that it is possible to push the internal panel inwards at the same time as the last two backings. · When the backings are in a corner wardrobe, they must support each other. Interior and Functionality · When placing the pull-outs, consider the corner strip (39 mm). Measuring · See the "Measuring" section on the back of this product catalogue for more detailed instructions. · You can get a measuring form at service.ka-as.dk/en. 46
Download PDF fil